Hello,
I had an error during Pumas Installation following the online instruction. I also did not see the “Enter License Key” prompt after typing the command “Julia: using Pumas”. I attached the error message and was wondering if you could please take a look and help me check the issue.
Thank yo so much!
Best, Indy
Hello,
Thank you very much for the instructions. Everything seemed to be working, and at the end of the installation I saw an “Enter License Key” prompt. However, I wasn’t sure why I couldn’t type in my license key or whether a special command was required. After that, the Julia interface suddenly closed, and the “Installing Pumpas@2.7.1” window appeared again with a message saying “History restored.” Please take a look at the following image.
Does this mean the installation was successful? Thank you!
Please try to start Pumas by selection “Open REPL” as in the screenshot I shared. If you are prompted for your license key then enter it. If not then you should be good to go.
Hello,
Thank you so much! After trying that, I got the following image. Please take a look. I could not type in my license. I was wondering if I did something wrong. Thanks!
You can press enter to enter the license key. You may be better off doing this in a regular terminal , like powershell where you type
julia and press enter.
This should take you into Pumas where you can start Pumas by calling
>julia using Pumas
Here when the prompt comes to enter license key, hit enter on the line which has > enter license key and you will get a place to enter the license.
Thank you so much, Vijay and Andreas! I appreciated your detailed instructions.
Now I believed that I completed the license activation and installation.
Best, Indy
